How it works, in three panels: 1) start with your existing light switch, 2) place the cover over the existing switch plate, 3) magnets hold it in place. No tools required.

How It Works

Nobody's seen one of these before, so here's the short version.

The magnets grab your screws.

Every standard switch plate is held on by two metal screws. The magnets in the back of the cover grab them. That's it. It sticks on.

How it works, in three panels: 1) start with your existing light switch, 2) place the cover over the existing switch plate, 3) magnets hold it in place. No tools required.

Nothing gets installed.

No tools. No wiring. Nothing gets drilled, glued, or damaged. Your switch works exactly as it did before, because you haven't touched it.

It comes off whenever you want.

Pull it off. Put it back. Move it to another room. Swap it for a different one. Renter-friendly by accident — we just didn't want to make you use a screwdriver.

What you need

A standard switch plate with metal screws. That's the whole requirement. If your screws are plastic, or painted over so thick the magnets can't reach, it won't hold.

Toggle or rocker?

Toggle is the little flip lever. Rocker is the wide flat paddle. Each cover fits one or the other — check the product page before you order.

SHOP ALL

Back to blog